Removing And Installing Charge Pressure Sender G31 / Intake Air Temperature Sender G42; Removing And Installing Charge Air Cooler - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Release fasteners -arrows- using release tool - T10527- and
release tool - T10527/1-
– Remove air pipe -1-.
Installation
Reassembly is carried out in the reverse order; note the following:
Note
Renew gaskets and O-rings.
2.3 Removing and installing charge pres‐
sure sender - G31- / intake air tempera‐
ture sender - G42-
Charge pressure sender - GX26- comprises:
♦ Charge-air regulator - G31-
♦ Intake air temperature sensor - G42-
Removing
– Unplug the electrical connector -1-.
– Release fasteners -arrows-, remove charge pressure sender
- GX26- .
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Replace the O-ring.
♦
If the retaining tabs broke off during removal, the sender can
♦
be secured using 2 fastening screws as per the ⇒ Electronic
parts catalogue . Tightening torque:
Specified torques
Component
Charge-air regulator - GX26-
2.4 Removing and installing charge air cool‐
er
Special tools and workshop equipment required
200
Rep. gr.21 - Turbocharging/supercharging
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 200 .
Tightening torque
3 Nm