Seat Leon 2013 Workshop Manual page 182

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Clamp off coolant hoses at coolant pipe with hose clamps
-3094- .
– Loosen the hose clips -arrows-, remove the coolant hoses.
– Now remove the intake manifold
– Lay intake manifold -1- on the workbench as shown.
– Place e.g. a block of wood -2- under the intake manifold as an
underlay.
Note
To avoid damaging the intake manifold and coolant pipe, this pro‐
cedure must be carried out very carefully!
– Insert a flat-blade screwdriver into the slot -arrow 1-.
– Carefully push the flat-bade screwdriver in
-direction of arrow 2- and lift the coolant pipe -4- in
-direction of arrow 3- until it comes free from the retainer.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Continue to lift the coolant pipe -1- in -direction of arrow- until
it comes free of the retainer -2-.
– Detach coolant pipe.
Installation
176
Rep. gr.19 - Cooling
⇒ page 229 .