Seat Leon 2013 Workshop Manual page 118

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove seal -1- using extractor hook -T20143/1- .
Installation
Note
Do not lubricate new seal.
– Push the seal -1- onto the guide sleeve -T10478/2- ; this is
done using the fitting sleeve -T10478/3- .
• Installation position: The closed side of the oil seal points to‐
ward the assembly sleeve.
– Separate fitting sleeve from guide sleeve.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Fit guide sleeve -T10478/2- with oil seal -1- onto camshaft.
– Draw in seal to stop using thrust piece -T10478/1A- and screw
-T10478/5- for camshaft pulley.
– Install camshaft adjuster
⇒ "3.3 Removing and installing camshaft adjuster",
page 104 .
112
Rep. gr.15 - Cylinder head, valve gear