Seat Leon 2013 Workshop Manual page 120

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Push the seal -1- onto the guide sleeve -T10478/2- ; this is
done using the fitting sleeve -T10478/3- .
• Installation position: The closed side of the oil seal points to‐
ward the assembly sleeve.
– Separate fitting sleeve from guide sleeve.
– Fit guide sleeve -T10478/2- with oil seal -1- to camshaft.
– Pull in thrust piece -T10478/1A- with bolt -T10478/5- as far as
stop.
– Install notched belt (adjusting valve timing)
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
3.5.3 Sealing ring on exhaust camshaft
(transmission side): removing and in‐
stalling
Special tools and workshop equipment required
114
Rep. gr.15 - Cylinder head, valve gear
⇒ page 89
respect to the correctness of information in this document. Copyright by SEAT S.A.
.