Supporting Engine In Installation Position - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
❑ Tightening torque and sequence
13 - Bolt
❑ renew
❑ 60 Nm + 90°
14 - Bolt
❑ renew
❑ 60 Nm + 90°
15 - Bolt
❑ renew
❑ 50 Nm + 90°
16 - Gearbox console
❑ With support arm
❑ Removing and installing
Engine support - Tightening torque and sequence
Note
Renew bolts that are tightened with specified further tightening
angle.
– Tighten bolts in stages in the sequence shown:
stage Bolts
1. -1 ... 3-
2. -1 ... 3-
3. -1 ... 3-
Installing pendulum support
Note
Renew bolts that are tightened with specified further tightening
angle.
– Tighten bolts in stages in the sequence shown:
stage Bolts
1. -2, 3-
2. -1-
3. -1 ... 3-
2.2 Supporting engine in installation posi‐
tion
Special tools and workshop equipment required
26
Rep. gr.10 - Removing and installing engine
⇒ page 26
⇒ page 29
Tightening torque/angle specification
7 Nm
40 Nm
turn 90° further
Tightening torque/angle specification
50 Nm
130 Nm
turn 90° further
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.