Removing And Installing Throttle Valve Module Gx3 - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Pull activated charcoal filter solenoid valve 1 - N80- -3- off in‐
take manifold and push it downwards slightly.
– Unplug electrical connector -2- for oil pressure switch.
– Undo hose clamps -2- and pull off coolant hoses.
– Remove bolts -arrows-.
– Remove intake manifold -1-.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Renew gaskets and O-rings.
– Install front noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
– Install air cleaner housing.
– Fill up with coolant ⇒ page 150
Specified torques
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 225
♦ ⇒ "4.1 Intake manifold - exploded view", page 228
4.3 Removing and installing throttle valve
module - GX3-
Throttle valve control unit - GX3- comprises:
♦ Throttle valve control mechanism - J338-
♦ Throttle valve drive (electric power control) - G186-
♦ Throttle valve drive angle sender 1 (electric power control) -
G187-
♦ Throttle valve drive angle sender 2 (electric power control) -
G188-
Special tools and workshop equipment required
232
Rep. gr.24 - Mixture preparation - injection
⇒ page 226
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.