Seat Leon 2013 Workshop Manual page 262

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
9 - Secondary silencer
❑ Combined in one unit with centre silencer as original equipment. Can be renewed individually for repair
purposes
❑ Removing and installing
❑ Disconnecting exhaust pipes/silencers
❑ Aligning exhaust system free of stress
10 - Mounting »C«
❑ Replace if damaged
❑ Aligning ⇒ page 257
11 - Holder
❑ Replace if damaged
12 - Bolt
❑ M8 x 25
❑ 20 Nm
Aligning mounting »A«
– Pre-tighten bolt.
– Using blunt side of commercially available 8 mm drill bit, align
holes -arrows- of mounting -A- centrally and parallel to longi‐
tudinal member.
– Using blunt side of commercially available 8 mm drill bit, align
holes-arrows- of mounting -A- centrally and parallel to longi‐
tudinal member.
– Then tighten to specified torque.
Aligning mounting »B«
– Pre-tighten bolt.
– Arrange hanger over the long hole bore
– Align holes -arrows- of mounting -B- centrally using blunt side
of commercially available 8 mm drill bit.
– Then tighten to specified torque.
256
Rep. gr.26 - Exhaust system
⇒ page 259
⇒ page 257
⇒ page 261
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.