Seat Leon 2013 Workshop Manual page 39

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove bolts -arrows- for engine mounting one by one and
renew (if they were not renewed when installing engine).
– First screw bolts in loosely.
– Remove bolts -arrows- for gearbox mounting -1- one by one
and renew (if they were not renewed when installing engine).
– First screw bolts in loosely.
– Using assembly lever, adjust engine/gearbox assembly so
that specifications listed below are attained:
There must be a distance of -a- = 10 mm between engine support
-2- and engine mounting -1-.
The side surface of the engine support -2- should be located par‐
allel to the support arm of the engine mounting -1-.
Distance -b- = distance -b-.
Note
For example, distance -a- = 10 mm can be checked with a metal
rod of suitable size.
– Tighten bolts for engine mounting.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Assembly mountings
33