4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Tool set for FSI engines - T10133 C- with -T10133/16 A- and
-T10133/19-
Removing
Note
♦
Risk of malfunction due to different procedures for installing
the injector seals.
Depending on the vehicle type, production date and injection
♦
pressure, injectors from different suppliers may be used.
Identify the part number or the relevant supplier as follows:
♦
⇒ page 213
Allocation is done using ⇒ Electronic parts catalogue .
♦
Identifying supplier or part number:
Position -A-: Information of the supplier.
Item -B-: part number.
Note
Risk of functional impairment due to soiling.
♦
⇒ "3.1 Rules for cleanliness", page 4
♦
Injectors must only be installed when the engine is cold.
♦
– Now remove the intake manifold
⇒ "4.2 Removing and installing intake manifold", page 229
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
.
213
2. Injectors