Crankshaft; Crankshaft Dimensions; Measuring Crankshaft Axial Clearance - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
3

Crankshaft

⇒ "3.1 Crankshaft dimensions", page 59
⇒ "3.2 Measuring crankshaft axial clearance", page 59
⇒ "3.3 Renewing needle bearing in crankshaft", page 60
3.1

Crankshaft dimensions

NOTICE
Risk of damage to bearing pedestals when the crankshaft is
removed.
If the bolts of the crankshaft bearing cap are loosened, the
bearing pedestals of the cylinder block will be deformed, and
damage to the bearings will result.
– Never remove the crankshaft.
Honing dimension
Basic dimension
3.2

Measuring crankshaft axial clearance

NOTICE
Risk of damage to bearing pedestals when the crankshaft is
removed.
If the bolts of the crankshaft bearing cap are loosened, the
bearing pedestals of the cylinder block will be deformed, and
damage to the bearings will result.
– Never remove the crankshaft.
Special tools and workshop equipment required
♦ Universal dial gauge bracket - VW 387-
Crankshaft bearing journal ∅
mm
42.00 –0.022
–0.042
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
59
3. Crankshaft