Seat Leon 2013 Workshop Manual page 54

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Fit guide sleeve -T10485/2- with oil seal -1- onto crankshaft.
– Draw in seal -2- to stop using thrust piece -T10485/1- and bolt
-1- for pulley.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Fit crankshaft sprocket onto crankshaft.
• The contact surface between vibration damper and crankshaft
toothed belt pulley must be free of oil and grease.
• Machined surface -arrow- of crankshaft sprocket must be posi‐
tioned over machined surface of crankshaft journal.
– Install notched belt (adjusting valve timing)
48
Rep. gr.13 - Crankshaft group
⇒ page 97 .