Seat Leon 2013 Workshop Manual page 189

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Removing
– Drain coolant ⇒ page 150
– Lift retaining clip -arrow- and separate coolant hose (top right)
from water radiator for charge air cooling circuit.
– Lift the retaining clip -arrow-, remove the coolant hose at the
top left from the radiator.
– Remove radiator cowl
– Use the removal wedge to press both sides of locking tab -1-
away from the engine compartment - 3409- and push the
radiator -in the direction of the arrow-.
– Pull radiator out of mountings at bottom.
– Remove radiator from water radiator for charge air cooling cir‐
cuit.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Remove coolant radiator upwards.
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Remove front bumper cover ⇒ General body repairs, exterior;
Rep. gr. 63 ; Front bumper; Removing and installing bumper
cover .
– Remove headlight ⇒ Electrical system; Rep. gr. 94 ; Remov‐
ing and installing headlights .
Vehicles with coolant bearing support, clipped in.
– Release catches -arrows- of radiator mounting -1- on left and
right, or pinch them off using side cutters.
Note
The radiator mount support is reused during installation. It will
then be bolted to lock carrier. Screws ⇒ ETKA (electronic spare
parts catalogue) .
.
⇒ page 187 .
León 2013 ➤ , León ST 2013 ➤
4. Radiator/radiator fans
183