Seat Leon 2013 Workshop Manual page 178

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unscrew bolt -1-, coolant and pull out temperature sender -
G62- -item 2-.
Note
If O-ring -3- with support ring -4- remains lodged in cylinder
♦
head, lift out O-ring with support ring using a piece of wire.
Insert new coolant temperature sender - G62- immediately in‐
♦
to cylinder head in order to avoid loss of coolant.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Replace the O-ring.
– Check the coolant level
Specified torques
♦ ⇒ "2.3 Exploded view - coolant temperature sensors",
page 161
2.8.2 Removing and installing coolant temper‐
ature sender at radiator outlet - G83-
Removing
• Engine cold.
– To relieve residual pressure in cooling system, open filler cap
-arrow- on coolant expansion tank briefly and then close cap
again (it should click into place).
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
172
Rep. gr.19 - Cooling
⇒ page 155 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.