Seat Leon 2013 Workshop Manual page 261

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Installation position of rear clamp
– Fit clamp in position shown.
• Permissible installation angle -α- = approx. 20°
• Bolt connections face to rear.
• Nuts facing upwards
1.1.2 Assembly overview: silencer, Leon ST
1 - Front silencer
❑ Combined in one unit
with rear silencer as
original equipment. Can
be renewed individually
for repair purposes
❑ Removing and installing
⇒ page 259
❑ Disconnecting exhaust
pipes/silencers
⇒ page 257
❑ Aligning exhaust sys‐
tem free of stress
⇒ page 261 .
2 - Holder
❑ Replace if damaged
3 - Mounting »A«
❑ Replace if damaged
❑ Aligning ⇒ page 256
4 - Bolt
❑ M8 x 25
❑ 20 Nm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
5 - Nut
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
❑ 30 Nm
6 - Clamp (rear)
❑ Align exhaust system so
it is free of stress before
tightening clamp
⇒ page 261
❑ Installation position
⇒ page 257
❑ Tighten bolted connec‐
tions evenly
7 - Mounting »B«
❑ Replace if damaged
❑ Aligning ⇒ page 256
8 - Bolt
❑ M8 x 25
❑ 20 Nm
León 2013 ➤ , León ST 2013 ➤
1. Exhaust pipes/silencers
255