León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Hot air blower - VAS 1978/14A- -item 1- with nozzle attach‐
ment -2- from wiring harness repair set - VAS 1978 B-
♦ Small grinder (commercially available)
♦ Vehicle diagnosis and service information system
Removing
– If engine control unit is renewed, select test sequence/function
Replace engine control unit on "vehicle diagnosis tester" in
"Guided functions" mode.
– Switch off ignition and remove key.
Note
If the engine control unit comes into contact with the positive
♦
battery terminal, permanent damage to the engine control unit
will be the consequence.
Therefore, the battery must be disconnected before the engine
♦
control unit is removed ⇒ Electrical system; Rep. gr. 27 ;
Battery; Disconnecting and connecting battery .
To remove protective housing -1-, unscrew shear bolts -arrows-
as follows:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Note
Cover the area around the engine control unit, and protect it from
flying sparks.
– Make groove (for a screwdriver) in head of shear bolt -1- using
a small grinder -2-.
242
Rep. gr.24 - Mixture preparation - injection