Seat Leon 2013 Workshop Manual page 14

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Locking pin - T10060 A-
♦ Protective glasses
♦ Protective gloves
Work sequence
Note
The engine is removed upwards using the lifting tackle -
♦
2024A- .
After removing of coolant or fuel lines, these must be sealed
♦
using the engine sealing cap set - VAS 6122- to prevent dirt
from entering or coolant or fuel from running out.
The cable clamps must be installed in their same place again.
♦
All cable ties which were opened or cut when the engine was
♦
removed must be replaced with new cable ties in the same
positions when engine is installed.
CAUTION
The cooling system is under pressure when the engine is hot.
Hot steam/hot coolant can escape - risk of scalding.
Risk of scalding to skin and body parts.
– Wear protection gloves.
– Use safety goggles.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
– Reduce pressure by covering the cap of the coolant expan‐
respect to the correctness of information in this document. Copyright by SEAT S.A.
sion tank with cloths and opening it carefully.
– Open filler cap -arrow- on coolant expansion tank.
8
Rep. gr.10 - Removing and installing engine