Seat Leon 2013 Workshop Manual page 271

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Detach electrical connectors -1- and -2- from the bracket and
separate. Move electrical wiring clear.
Note
Prior to loosening the connection between the catalytic con‐
♦
verter and the turbocharger, mark position of the clamp
⇒ page 265 .
According to the part which is to be replaced, the part in front
♦
of it must be marked.
The clamp must be positioned at the same place on reassem‐
♦
bly.
Clamp position
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Unscrew bolt -2- and remove screw-type clip.
– Remove bolt -1- and nuts -arrows-.
– Unscrew bolts -arrows- for bracket.
León 2013 ➤ , León ST 2013 ➤
2. Emission control
265