Seat Leon 2013 Workshop Manual page 237

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Open hose clips -arrows-, and remove air hose -1-.
– Pull connector off charge pressure sender - GX26- .
Note
Make sure to use the new tools to prevent the locking lugs of the
air intake pipe from breaking off.
– Remove air intake pipe
⇒ "2.2 Removing and installing the air intake pipe",
page 199 .
– Release the fastener -arrow-, remove the vacuum hose -1-.
– Remove screw -1-, release upper clips -arrows- a remove
coolant hoses.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Unplug electrical connectors:
1 - For activated charcoal filter solenoid valve 1 - N80-
3 - for throttle valve control unit - GX3-
4 - For the intake manifold pressure sensor - GX9-
Note
Disregard -arrow-.
– Remove bolt -arrow-.
– Press release buttons and pull off hose -2- for activated char‐
coal filter.
– Unclip fuel supply line -5- and coolant line -6- from intake
manifold and push them to one side.
León 2013 ➤ , León ST 2013 ➤
4. Intake manifold
231