León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Work sequence
– Remove throttle valve module - GX3-
– Open throttle valve by hand and lock it in open position with a
wedge (plastic or wood) -arrow-.
CAUTION
Risk of injury caused by acetone. Acetone is highly flammable
and may cause eye and skin irritation.
– Use safety goggles.
– Wear protection gloves.
– Clean throttle valve housing thoroughly, especially around the
points -arrows- where the throttle valve closes, using com‐
mercially available acetone and a small brush.
– Wipe out throttle valve housing with a lint-free cloth.
– Allow the acetone to dry completely.
– Install throttle valve module - GX3-
– Erase learnt values and adapt engine control unit - J623- to
throttle valve module - GX3- . Use vehicle diagnostic tester
234
Rep. gr.24 - Mixture preparation - injection
⇒ page 232
⇒ page 232
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
.