León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove toothed belt -1- together with crankshaft pulley -2-
from crankshaft journal.
•
Milled surface of crankshaft sprocket -arrow- must be posi‐
tioned on milled surface of crankshaft journal.
•
Contact surface between poly V-belt pulley and crankshaft
sprocket must be free of oil and grease.
Note
Renew bolts that are tightened with specified further tightening
♦
angle.
Renew O-ring of plug if damaged.
♦
– Renew bolt -2- for camshaft adjuster on inlet side, and screw
it in to stop by hand.
– Renew bolt -1- for toothed belt pulley on exhaust side, and
screw it in to stop by hand.
•
It should just be possible to turn the adjusters on the camshafts
without axial movement.
•
The sheet-metal tab -arrow- of the belt tensioner must engage
in the cast notch of the cylinder head.
Observe sequence when fitting the toothed belt
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
98
Rep. gr.15 - Cylinder head, valve gear