Seat Leon 2013 Workshop Manual page 187

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Wedge - 3409-
Removing
– Drain coolant ⇒ page 150
– Remove radiator cowl
– Lift the retaining clip -arrow-, remove the coolant hose at the
top left from the radiator.
– Use the removal wedge to press both sides of locking tab -1-
away from the engine compartment - 3409- and push the
radiator -in the direction of the arrow-.
– Pull radiator out of mountings at bottom.
– Remove radiator from water radiator for charge air cooling cir‐
cuit.
– Remove radiator (top section).
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
If there are minor dents in the fins, refer to respective instruc‐
♦
tions ⇒ page 6 .
Renew O-rings after removal.
♦
.
⇒ page 187 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
4. Radiator/radiator fans
181