Seat Leon 2013 Workshop Manual page 199

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unscrew bolts -arrows- and detach oil supply pipe -1- and oil
return pipe -2-.
– Unscrew bolt -2- and remove screw-type clip.
– Remove bolt -1- and nuts -arrows- and tie up catalytic con‐
verter.
– Remove resonator for intake air
⇒ "3.3 Removing and installing resonator for intake air", page
227 .
– Free air hose from air pipe.
– Open hose clips -arrows-, and remove air hose -1-.
– Pull connector off charge pressure sender - GX26- .
Note
Make sure to use the new tools to prevent the locking lugs of the
air intake pipe from breaking off.
– Remove air intake pipe
⇒ "2.2 Removing and installing the air intake pipe",
page 199 .
– Press release tabs and disconnect hose -1- for activated char‐
coal filter.
Note
The bolts -arrows- are provided with a coating. They must be re‐
newed after removal!
– Remove bolts -arrows- and detach crankcase breather hose.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
1. Turbocharger
193