Seat Leon 2013 Workshop Manual page 63

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Checking sender wheel installation position on crankshaft:
– Screw nut -B- to end of threaded spindle.
– Remove both bolts -2- from cylinder block.
– Screw out the guide pins for petrol engines (red handle) -F-
from the crankshaft flange.
– Unscrew knurled screws -H- from sealing flange -1-.
– Unbolt assembly tool - T10134- from crankshaft flange (re‐
move hexagon socket head bolts -E- from crankshaft flange).
– Remove the pressure ring from the sealing lip.
– Apply depth gauge - VAS 6082- to crankshaft flange -2-.
– Measure distance between crankshaft flange -2- and sender
wheel -1-.
– Measure distance -a- between crankshaft flange -2- and sen‐
sor wheel -1-.
• Specification: Distance -a- = 0.5 mm
– Press sensor wheel in further if distance is too small
⇒ page 57 .
– If reading matches specification, continue with assembly
⇒ page 58 .
Re-pressing sender wheel:
– Secure assembly tool - T10134- on crankshaft flange.
– Take care to ensure that the locating pin of the assembly tool
- T10134- is seated in the hole in the sender wheel.
– Hand-tighten hexagon socket head bolts -E-.
– Slide assembly tool - T10134- onto sealing flange -1- by hand.
– Screw nut -B- onto threaded spindle by hand until it touches
assembly tool - T10134- .
– Push guide pin for petrol engines (red handle) -F- into crank‐
shaft flange.
– Screw knurled screws -H- onto sealing flange -1-.
– Screw two bolts M6 x 35 mm -2- into cylinder block to guide
the sealing flange.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Cylinder block, gearbox end
57