Removing And Installing Engine Speed Sensor G28 - Seat Leon 2013 Workshop Manual
Hide thumbs
Also See for Leon 2013:
- Workshop manual (395 pages) ,
- Workshop manual (464 pages) ,
- Workshop manual (24 pages)
Table of Contents
Advertisement
León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Unplug the electrical connector -1-.
– Unscrew bolt -2- and remove Hall sender - G40- .
Installation
– Installation is in the reverse sequence of removal.
Specified torques
♦
⇒ "1.1 Assembly overview - ignition system", page 268
1.6
Removing and installing engine speed
sensor - G28-
Special tools and workshop equipment required
♦ Socket 4 mm - T10370-
Removing
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
– Unscrew bolts -arrow- and push charge air cooling pump -
V188- to one side.
272
Rep. gr.28 - Ignition system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Advertisement
Table of Contents
