Seat Leon 2013 Workshop Manual page 173

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
♦ Hose clamps, up to Ø 25 mm - 3094-
♦ Drip tray for workshop hoist - VAS 6208-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Hose clip pliers - VAS 6362-
Removing
– Open filler cap -arrow- on coolant expansion tank.
CAUTION
The cooling system is under pressure when the engine is hot.
Hot steam/hot coolant can escape - risk of scalding.
Risk of scalding to skin and body parts.
– Wear protection gloves.
– Use safety goggles.
– Reduce pressure by covering the cap of the coolant expan‐
sion tank with cloths and opening it carefully.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
León 2013 ➤ , León ST 2013 ➤
2. Coolant pump/thermostat assembly
167