Seat Leon 2013 Workshop Manual page 249

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
Note
The threads of the shear bolts are secured with locking fluid. To
unscrew these bolts, the threads must therefore be heated with
the hot air blower.
– Set the hot air blower as shown in illustration. Meaning poten‐
tiometer for temperature regulation -2- set to maximum heat‐
ing power and 2-stage switch for air volume -3- set to position
3.
NOTICE
Risk of damage to adjacent components caused by hot air
blower. Risk of overheating.
– If necessary, cover adjacent components.
– Heat head of shear bolt -1- for approx. 20 to 30 seconds.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Unscrew shear bolt -1- using screwdriver -2-.
León 2013 ➤ , León ST 2013 ➤
6. Engine control unit
243