Wheel Bearing; Assembly Overview - Wheel Bearing; Removing And Installing Wheel Bearing Housing - Seat Leon 2013 Workshop Manual

5

Wheel bearing

⇒ "5.1 Assembly overview - wheel bearing", page 87
⇒ "5.2 Removing and installing wheel bearing housing",
page 87
⇒ "5.3 Removing and installing wheel bearing unit", page 93
5.1

Assembly overview - wheel bearing

1 - Protective plate
2 - Bolt
❑ 12 Nm
3 - Wheel bearing unit
❑ Removing and installing
⇒ page 93
❑ Cannot be repaired
4 - Bolt
❑ Always renew after re‐
moving
❑ Loosening and tighten‐
ing ⇒ page 120
❑ 200 Nm +180°
5 - Wheel bearing housing
❑ Different versions possi‐
ble. Refer to ⇒ Electron‐
ic Parts Catalogue "ET‐
KA" .
❑ Removing and installing
⇒ page 87
6 - Bolt
❑ Always renew after re‐
moving
❑ 70 Nm +90°
7 - Drive shaft
❑ Do not let drive shaft
hang down under its
own weight when per‐
forming repair work, as
otherwise excessive
bending could damage
inner CV joint
❑ Before assembling the outer joint into the wheel hub, the splines of the outer joint must be coated with
the assembly paste ⇒ Electronic parts catalogue "ETKA" .
5.2 Removing and installing wheel bearing
housing
Special tools and workshop equipment required
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
87
5. Wheel bearing