Mixture Preparation - Injection; Injection System; Overview Of Fitting Locations - Injection System - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
24 –

Mixture preparation - injection

1

Injection system

⇒ "1.1 Overview of fitting locations - injection system",
page 205
⇒ "1.2 Reducing fuel pressure in high-pressure section",
page 208
1.1 Overview of fitting locations - injection
system
⇒ "1.1.1 Fitting location overview - injection system, engine com‐
partment", page 205
⇒ "1.1.2 Overview of fitting locations –engine, intake side",
page 207
⇒ "1.1.3 Overview of fitting locations – engine, exhaust side", page
208
1.1.1 Fitting location overview - injection system, engine compartment
1 - Camshaft control valve 1 -
N205-
❑ Exploded view
⇒ page 70
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
2 - Lambda sensor 1 before
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
catalytic converter - GX10-
respect to the correctness of information in this document. Copyright by SEAT S.A.
❑ comprising:
Lambda sensor - G39-
Lambda probe heater -
Z19-
❑ Exploded view
⇒ page 250
3 - Lambda probe 1 after cata‐
lytic converter - GX7-
❑ comprising:
Lambda probes after the
catalytic converter -
G130-
Lambda probe heater 1
after catalytic converter -
Z29-
❑ Exploded view
⇒ page 250
4 - Charge pressure positioner
- V465-
❑ Removing and installing
⇒ page 195
5 - Engine control unit - J623-
❑ Removing and installing
⇒ page 239
León 2013 ➤ , León ST 2013 ➤
1. Injection system
205