Removing And Installing Pendulum Support - Seat Leon 2013 Workshop Manual

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Remove bolts -arrows- and detach gearbox mounting -1-.
Installation
Installation is carried out in the reverse order. Please note the
following:
Note
Renew bolts that are tightened with specified further tightening
angle.
Note
Renew bolts that are tightened with specified further tightening
♦
angle.
Gearbox support and support arm of gearbox mounting must
♦
be perfectly parallel to each other before screwing in bolts
-arrows 1-. If necessary, lift gearbox at rear using trolley jack.
Only remove support bracket - 10 - 222 A- when bolts on as‐
♦
sembly mounting have been tightened to specified torque.
– Pull gearbox up with spindle on support bracket until gearbox
support contacts support arm of gearbox mounting.
– Check adjustment of assembly mountings (engine/gearbox
mountings) ⇒ page 32
– Remove the gearbox support - 10 - 222 A- from the engine.
Specified torques
♦ ⇒ "2.1 Exploded view - assembly mountings", page 25
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 225
♦ ⇒ Electrical system; Rep. gr. 27 ; Battery; Assembly overview
- battery
♦ ⇒ "6.1 Removing and installing engine control unit J623 ", page
239
♦ ⇒ General body repairs, exterior; Rep. gr. 63 ; Front bumper;
Assembly overview - bumper cover
♦ ⇒ Electrical system; Rep. gr. 92 ; Windscreen washer system;
Assembly overview - windscreen washer system
2.5 Removing and installing pendulum sup‐
port
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 50 ; Noise insulation; Removing and installing noise
insulation .
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
León 2013 ➤ , León ST 2013 ➤
2. Assembly mountings
31