Valve 1 For Variable Distribution N205 Removing And Fitting - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
– Push the seal -1- onto the guide sleeve -T10479/2- ; this is
done using the fitting sleeve -T10479/3- .
• Installation position: The closed side of the oil seal points to‐
ward the assembly sleeve.
– Separate fitting sleeve from guide sleeve.
– Fit guide sleeve -T10479/2- with oil seal -2- centrally to cam‐
shaft.
– Secure guide sleeve onto camshaft using bolt -1- for coolant
pump drive sprocket.
– Push seal onto camshaft and unbolt guide sleeve.
– Draw in seal -2- to stop using thrust piece -T10479/1- and bolt
-1- for toothed belt pulley for coolant pump.
– Install toothed belt pulley for coolant pump
3.6 Valve 1 for variable distribution - N205-
removing and fitting
Removing
Valve 1 for variable distribution - N205-
– Unplug the electrical connector -1-.
116
Rep. gr.15 - Cylinder head, valve gear
⇒ page 166
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.