Seat Leon 2013 Workshop Manual page 164

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
5 - Bolt
❑ Thread-forming
❑ Fit and screw in bolt by hand so that it is screwed into old thread. Then tighten the screw with the stated
torque
❑ Tightening torque and sequence
6 - Seal
❑ renew
❑ Observe proper seating of seal.
❑ Lightly coat with coolant before installing.
7 - Toothed belt guard
❑ For toothed belt for coolant pump
8 - Bolt
❑ renew
❑ 20 Nm + 90°
9 - Notched belt
❑ Renew when exchanging coolant pump.
❑ For coolant pump drive
❑ Removing and installing
10 - Toothed belt sprocket
❑ For coolant pump drive
❑ Removing and installing
❑ Before removing, the cylinder 1 must be moved to TDC position.
11 - Bolt
❑ 8 Nm
12 - Bolt
❑ Thread-forming
❑ Fit and screw in bolt by hand so that it is screwed into old thread. Then tighten the screw with the stated
torque
❑ Tightening torque and sequence
13 - Cover
❑ For thermostat
14 - Seal
❑ renew
❑ Lightly coat with coolant before installing.
15 - Thermostat
❑ For large cooling circuit
❑ until 11.2012: opening start at about 80 °C
❑ from 11.2012: opening start at about 87 °C
❑ Removing and installing
❑ Installation position
16 - Bolt
❑ Tightening torque and sequence
158
Rep. gr.19 - Cooling
⇒ page 159
⇒ page 162
⇒ page 166
⇒ page 159
⇒ page 168
⇒ page 159
⇒ page 165
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
.
.