Seat Leon 2013 Workshop Manual page 77

4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
1 - Bolt
❑ Tightening torque and
sequence ⇒ page 72
2 - Camshaft control valve 1 -
N205-
❑ Removing and installing
⇒ "3.6 Valve 1 for vari‐
able distribution N205
removing and fitting",
page 116
❑ Check O-ring for dam‐
age.
❑ O-ring not available as a
separate part; renew to‐
gether with camshaft
control valve 1 - N205- if
damaged.
3 - Bolt
❑ 8 Nm
4 - Camshaft housing
❑ Removing and installing
⇒ "1.4 Removing and in‐
stalling camshaft hous‐
ing", page 76
5 - Hall sender - G40-
❑ Removing and installing
⇒ "1.5 Removing and in‐
stalling Hall sender",
page 271
6 - Bolt
❑ 8 Nm
7 - Oil seal
❑ For exhaust camshaft,
gearbox end
❑ Replace
⇒ "3.5.3 Sealing ring on exhaust camshaft (transmission side): removing and installing", page 114
8 - Toothed belt sprocket
❑ For the coolant pump
❑ Removing and installing
⇒ "2.5 Removing and installing toothed belt pulley for coolant pump", page 166
9 - Bolt
❑ Tightening torque
10 - Bolt
❑ 8 Nm
11 - Sealing cap
12 - O-ring
❑ renew
13 - Seal
❑ renew
14 - Split pin
15 - Seal
❑ With oil strainer
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ "2.1 Exploded view - coolant pump and thermostat", page 157
León 2013 ➤ , León ST 2013 ➤
1. Cylinder head
71