Seat Leon 2013 Workshop Manual page 134

León 2013 ➤ , León ST 2013 ➤
4-cylinder petrol engine (1.2 l direct injection, 4 V, turbocharger, EA211) - Edition 02.2017
14 - Oil drain plug
❑ renew
Note
Only renew at the first oil change
following the factory fitting.
⇒ page 129
❑ 30 Nm
15 - Suction pipe
16 - Bolt
❑ 8 Nm
17 - Bolt
❑ For tensioning assembly
❑ renew
❑ 20 Nm + 90°
18 - Oil seal
❑ Replace ⇒ page 46
❑ For oil pump drive
19 - Bolt
❑ renew
❑ Specified torques
20 - Oil pump
❑ Removing and installing
21 - Seal
❑ renew
❑ Note guide pins for proper positioning.
Sump - tightening torque and sequence
– Tighten bolts in stages in the sequence shown:
stage Bolts
1. -1 ... 19-
2. -1 ... 19-
128
Rep. gr.17 - Lubrication
⇒ page 136 .
⇒ page 134
Tightening torque
Screw in by hand until they make con‐
tact
8 Nm + 90°
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.