Display Interface - HP E4510-48G Command Reference Manual

Duplex
PVID

display interface

Syntax
display interface [ interface-type [ interface-number ] ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type: Type of a specified interface.
interface-number: Number of a specified interface.
Description
Use the display interface command to display the current state of a specified interface and related
information.
If neither interface type nor interface number is specified, all interface information will be
displayed.
If only interface type is specified, then only information of this particular type of interface will be
displayed.
If both interface type and interface number are specified, then only information of the specified
interface will be displayed.
Related commands: interface.
Examples
# Display the current state of interface GigabitEthernet 1/0/1 and related information.
<Sysname> display interface GigabitEthernet 1/0/1
GigabitEthernet1/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e200-8048
Description: GigabitEthernet1/0/1 Interface
Loopback is not set
Media type is twisted pair, port hardware type is 100_BASE_TX
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9216
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Field
1-6
Description
Duplex mode, which can be half (half duplex),
full (full duplex), or auto (auto-negotiation).
Default VLAN ID