Console Port; Reset Buttons; Module Reset; System Reset - HP 8200 zl Installation And Getting Started Manual

Spd
■ If the speed indicator LED is lit, the port LEDs behave as follows to
indicate the connection speed for the port:
• Off = 10 Mbps
• Blinking = 100 Mbps (the blinking behavior is a repeated on/off cycle
once every 0.5 sec.)
• On = 1000 Mbps
PoE
■ If the indicator LED is lit, the Link and Mode LEDs indicate PoE status:
Link LED:
• On = PoE is enabled on this port
• Off = PoE is disabled on this port.
• Slow Blinking = Internal PoE fault on this port.
• Fast Blinking = This port is denied PoE power or has an external load
fault.
Mode LED:
• On = PoE power is be supplied on this port
• Off = PoE is not being supplied on this port.

Console Port

This port is used to connect a console to the switch by using the serial cable
supplied with the switch. This connection is described under "Connecting a
Console to the Switch" in chapter 2, "Installing the the 8200 zl Switch". The
console is a full-featured interface that can be used to configure, monitor, and
troubleshoot the switch. It can be run on a PC, laptop, or handheld device
emulating a VT-100 terminal, or on a standard VT-100 terminal.

Reset Buttons

Module Reset

This button, located on the Management module, will reset the Management
module only.

System Reset

This button, located on the System Support Module, will reset the switch when
powered on. This action clears any temporary error conditions that may have
occurred, executes the switch self test, and resets all network activity coun-
ters to zero.
The counters are displayed in the switch console interface, the switch web
browser interface, and through SNMP network management applications,
such as ProCurve Manager.
Introducing the HP 8200 zl Switches
Front of the 8200 zl Switches
1-13