Igmp-Snooping Static-Router-Port; Igmp-Snooping Version - HP 6125G Command Reference Manual

[Sysname-GigabitEthernet1/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1
vlan 2

igmp-snooping static-router-port

Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN, where vlan-id is in the range of 1 to 4094.
Description
Use igmp-snooping static-router-port to configure the current port as a static router port.
Use undo igmp-snooping static-router-port to restore the default.
By default, no ports are static router ports.
This command works in both IGMP snooping–enabled VLANs and VLANs with IGMP enabled on their
VLAN interfaces.
This command does not take effect in a sub-VLAN of a multicast VLAN.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
Related commands: subvlan.
Examples
# Configure GigabitEthernet 1/0/1 in VLAN 2 as a static router port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping static-router-port vlan 2

igmp-snooping version

Syntax
igmp-snooping version version-number
undo igmp-snooping version
View
VLAN view
Default level
2: System level
29