Table of Contents
Advertisement
3 Maintenance
3.3.12 Inspecting Signal lamp (option)
3.3.12 Inspecting Signal lamp (option)
Location of signal lamp
Signal lamp is an option.
Located as shown in the figure.
xx0800000290
A
B
C
D
Required equipment
Equipment
Signal lamp
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Inspecting signal lamp
Use this procedure to inspect the function of the signal lamp.
1
Continues on next page
142
Signal lamp
R3.H1 +, R3.H2 -
R2.CP
R2.CS
Note
If the signal lamp is damaged, it shall be replaced!
Action
Check that the signal lamp is lit when motors
are put in operation ("MOTORS ON").
© Copyright 2009-2021 ABB. All rights reserved.
A
B
C D
Note
For spare parts no. see Spare parts - Spare
parts options in Product manual, spare
parts - IRB 2600.
Content is defined in section
on page
385.
These procedures include references to the
tools required.
Note
Standard tools
Product manual - IRB 4600
3HAC033453-001 Revision: Y
Advertisement
Table of Contents
