Table of Contents
Advertisement
Installation, fan on motor axis 2
Use this procedure to install the cooling fan on motor axis 2.
1
2
3
4
5
6
Product manual - IRB 4600
3HAC033453-001 Revision: Y
Action
DANGER
Turn off all:
•
electric power supply to the robot
•
hydraulic pressure supply to the robot
•
air pressure supply to the robot
Before entering the robot working area.
Remove the back plate of the fanbox.
Place the fanbox around motor axis 1.
Refit the back plate of the fanbox.
Fit the fanbox with two attachment screws
M6x30.
Connect the fan connector to motor and fan.
© Copyright 2009-2021 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Installation of cooling fan for motors (option)
Note
See the figure in:
•
Cooling fan on page 83
See the figure in:
•
Cooling fan on page 83
xx0900000405
Parts:
•
A: Connector, signal
•
B: Connector, power
•
C: Fan cable
•
D: Connector, fan
•
E: Cable gland
•
F: Motor cover, with fan cable
Continued
Continues on next page
87
Advertisement
Table of Contents
