PEUGEOT 504 Series 1970 Workshop Manual page 62

0
UJ
\J
:J
UJ
Q.
3-72
ENGINE
CYLINDER LINERS - REFITTING
- Install the liner compressing tool as shown opposite.
Check the setting of the dial gauge at 5 and 0 on
the block .
- Check the protrusion at
(A), (B), (C)
and
(D).
The protrusion at the highest point should be as
close as possible to 0.11 mm (point c).
The maximum difference between the diametri-
cally opposed points (A). (C} and (B), (D} must
be
less than 0.07 mm.
- If
1t
is more. find the reason.
- Set the dial gauge at 0 on point 84 (liner N° 4l.
- Place the dial gauge on point
03
(liner N° 3).
The difference in protrusion between the two
liners must not exceed 0 .04 mm (point d).
If i t does, change the gasket on the liner which
protrudes the most and fit a gasket one size
sma ller.
- Turn the compressor round and check the liners 1
and 2.
Remove the compressor and tit the retaining
screws.
WWW.~
C::J llCl .OrG
1212 E