PEUGEOT 504 Series 1970 Workshop Manual page 197

GEARBOX
RE-ASSEMBLY
- Loosen the four housing bolts.
- Str ike the half housings with a mallet while
rotat 1ng the drive shaft.
- Re-tighten the four bolts
Tightening torque· 11.00 ft.lbs
(1.5
m.kg).
- Uso dial indicator support F to check the out·
of-flush of the half hous 1ngs ot the1 r rear ma-
ting surface. The housings must not be out-
of-flush by
mor~
than 0.02 mm.
- lns•oll the four assembling bolts and nuts of
the half housings.
- Tighten these 4 bolts to 7.2 ft.lbs
(1
m.kg)
- Smear the mating surface of the rear housing
with "Perfect seal
it
N° 4 compound.
- Install the rear housing.
- E ngoge :
- three double-thread studs
1,
- four attaching bolts 2.
- Pull selector lever 3 fully backwards.
- Tighten the seven bolts and studs
Tightening torque : 11.00 ft.lbs (1.5 m.kg).
- Oil the «Nadella11 bearing of the rear housing.
WWW.'!::ii CJ Cl .OrG
I
I