PEUGEOT 504 Series 1970 Workshop Manual page 175

Preliminary conditions
- Al I ports must be perfectly clean
GEARBOX
RE · ASSEMBLY
- Mating surfaces smeared with «Perfect seal» sealing compound should be cleaned using a fluffless cloth
moistened with industrial grade methylated spirit exclu sively. NEVER USE EMERY CLOTH or CUTTING
TOOLS.
- The following ports must be replaced systematically:
- snap rings used on shafts,
- spring washers,
- Mecanindus pins,
- Spiral pin (reverse shaft),
- ma1nshaft nut,
- moinshaft rear oil seal,
- speedometer drive socket «0» seal ring,
- all Onduflex and Blocfor washers,
- engine drive shaft bearing deflector washer.
- All components should be smeared with ESSO EXTRA MOTOR OIL 20 W 30/ 40 before installing them.
WVIW. E. CJ llCJ .OrG