0
w
~
~
w
0.
GEARBOX
GEAR
CHANGE CONTROLS
SETTING
THE CONSOLE
The heater and the gearbox tunnel are
covered by an adjustable console.
After adjusting the controls, it is necess-
ary to check the position of the lever in 1 st
gear, as in this position it may come into contact
with the edge of the cutaway in the console.
In this case it is necessary to reset the
position of the console to ensure a minimum gap
of 10 mm between the console and gear change
lever in all the gear positions.
REMOVAL
Disconnect the battery
· Remove the front seats
• Unscrew the gear change lever bol I
· Remove the ashtray
· Disconnect the cigarette I ighter
· Remove the console.
- Unscrew the four screws and push the heater
control support
1
forwards.
• Retighten the four screws.
-
Slocke n the nut and move the front
console
sup port
2
forwards.
Do not tighten the nut yet
- The
rear
support, on
the
tunnel, is not adjustable
and
the console is secured with self tapping
screws.
504 Workshop Manual • Ref. 1212 E
WVIW.
E.
CJ llCJ .OrG