PEUGEOT 504 Series 1970 Workshop Manual page 569

HULL - FRONT P A RT
REPLACING A FRONT PART OF THE BUTTRESS AND A FRONT FRAMEWORK PANEL
- Remove the fastening bolts, raise the hull (by
he door fromes}, remove the telescopic towers
(new buttress side}.
• l,Y
1
th the assembly
[ID
Spot weld .
(n) • the buttress
(o) • the wing volonce
to the buttress sole plote.
NO TE· Because of the point between the mech·
onicol fastening reinforcement panels, correct
welding
1s
not always possible.
· In this case :
Torch weld the valance, the buttress and the
sole plates at the mechanical fastening rein for·
cement level (p).
• With the assembly
IQ
Spot weld the upper part of the battery supports
(q) to the wing valance at 290 mm from the bulk-
head and leaving 290 mm space between them
(L.H. side).
· T arch weld :
(r) • the lower port of the battery supports to
the buttress sole plate
(s ) · the end of the sole plate to the joint bulk-
head-front floor.
PROTECTION AND SEAL ING
• Apply a coot of soun d proofing product on the
outer su rface of the wing valance
· Point the buttress, the framework panel and the
ports cleaned for welding