PEUGEOT 504 Series 1970 Workshop Manual page 213

P R 0 P E LL E R S H A F T
REFITTING
- Using two Allen screws equipped with new
Blodor washers, equipped with counter plates,
secure the differential to the suspension cross-
member.
·Tighten the screws to 27 ft.lbs (3.75 m.kg}.
- Refit the heat dissipation plate.
- Ref t the exhaust pipe assembly and install a
new clamp gasket.
- Properly centre the assembly to avoid contact
with the connecting tube, the rear crossmember
and the floor.
- Place a jack under the righthand lateral support
and raise the crossmember until it comes into
contact with the floor.
- Remove guide
Kl. .
- Close the guide hole using the plastic plug.
- Following the order given below, install the
following parts on the studs :
- the
f
lot washers
- o new tab lock
- the securing nuts must be tightened either at :
29 ft.lbs (4 m.kg) up to the serial numbers
mentioned below or47ft.lbs(6.5 m.kg) as from
the same serial numbers :
504
AOl •
1 005 546
504 A02 - 1 003 649
504
A03 ·beginning of series
504 802 • 1 032 357
504 C02 - 1 009 769
- Leck by bending the tab toogues over the nuts.
• To secure the rear crossmember in position car-
ry out the same operations on the left hand
side.
- Refit the rear seat cushion.
- Grease the prope Iler shaft centre bearing.
- Check gearbox oil level : top up
if
necessary
using ESSO EXTRA MOTOR OIL 20 W 30/ 40.