PEUGEOT 504 Series 1970 Workshop Manual page 524

0
w
\J
::>
w
a.
BODYWORK
REMOVAL
Separate the rear axle from the bodywork
• Place a 1ack under the cross tnember loterol
left hond support.
• Remove the rear seat cushion.
• Unlock the three securing nuts of the cross
member.
• Remove the front securing nut.
·Raise the tab lock and remove the guide hole
plastic plug.
• Fully screw in gu ide rod
Kl
in
the hole thus
exposed and tighten us ing bar K2.
• Leave bor K2 in the guide hole.
• Remove the cross member rear securing nuts
and thrust washers.
• Lower the cross member progressively until
the bar comes into contact with the floor.
• Carry out the some operation on the right hand
side.
• Remove both tightening clomps of the anti-<ol I
bar flexible bushes under the bodywork.
504 W ork$hop Manual • Rei. 1212 E
WVIW. ~~lllC:J . OrG