PEUGEOT 504 Series 1970 Workshop Manual page 189

GEARBO X
RE-ASSEMBL Y
- Turn the dial indicator support until the ndi-
cotor finger 1s 1n contact with the upper edge
of 2 nd gear synchronizer cone
1.
- The clooronce obtained indicates the thick-
ness of the shims to be inserted between the
1
st gear pin ion bushing
2
and rear bearing
3.
·The above value should be rounded to the
nearest 0.05 mm .
Example :
Ind icator reading : 0 .47 mm
- Prepare a 0.45 mm stock of shims and store it
in the location provided in the cover of the
chest.
- Remove
- moinshoft and gouge B
- R.H. half housing,
-drive shaft.
H.B. • Shims are avatlable in the following
thicknesses
0.15
mm
0.20
mm
ADJUSTMENT N° 3
0.25
mm
0.50
mm
·Secure the L.H. hous ing on support base
8 .0311.
- Install intermediate georshoft 4 , equipped
with its bearings and rear plate, in the housing.
WWW.!::::. c:J Cl .OrG