PEUGEOT 504 Series 1970 Workshop Manual page 191

GEARBO X
RE-ASSEMBLY
- Using dial indicator support F , make sure that
the half housings ore not out of flush by more
than 0.02 mm.
• If they ore, replace the clutch housing and re·
commence tightening as previously described.
• Locate the indicator support on the interme-
'diote georshoft end face, and engage it in the
intermediate georshoft bore.
·Rotate the dial indicator one complete revolu-
tion on the outer race of the rear bearing.
- The out of parallel of the race,
with
respect
to the rear face of the half housings, must not
exceed 0.02 mm.
• If the above value 1s exceeded, the race
should be straightened by striking it lightly
with a mallet through drift S.
·Make sure the above operation does not tighten
the intermediate gears haft.
- Both bolts
1
should be loosened, and then re-
tightened if bind is noted in the shaft.
• Repeot the check for parallelism.
WWW.!::::. c:J Cl .OrG