PEUGEOT 504 Series 1970 Workshop Manual page 568

0
w
~
::J
w
a.
8 70
HULL - FRONT PART
REPLACING A FRONT PART OF THE BUTTRESS AHO A FRONT FRAMEWORK PANEL
• Fit the front port of the buttress on the bench .
- Place the plate on the end of the buttress and
centre 1t in relation to the cut ( b).
· Torch weld
(c) · !3y overlapping the plate to the inside of
the buttress
(d) - Edge to edge on the outs ide, the adjust-
ment cut. Smooth the welding.
- Place and fit the buttress sole plate.
• With the assembly
[!]
Electric spot weld :
(e)-the inner port ond the end of the sole plate
(f) • the lower cross piece
to the buttress .
Spot weld the end of the wing volonce (e)
Hold the framework panel with mole grips.
Electric spot weld
(g) ·the front port of the valance
(h) ·the lower cross piece
(i) •
the cross piece support
to the framework panel.
(j) ·the lower bracket to the buttress (k) and
thevolonce (1)
· With the assembly
(ID
Spot weld :
(m)· the upper cross piece to the framework
panel.
50.1 W orkshop M onua -
R~I.
1212 E
WVIW. ~~lllC:J . OrG