PEUGEOT 504 Series 1970 Workshop Manual page 309

Table of Contents

Advertisement

REAR
AXLE
REAR
ARMS
REFITTING
- Only fit parts which are clean and free from
all defect.
- Check particularly the condition of the flexible
bushings. In case of doubt, replace them follow-
ing the method indicated (Class 5, page 16 11).
- Use new "Nylstop" nuts and
new
"Blocfor"
and "Onduflex" washers.
- Position the rear arm
in the corresponding
yokes on the crossmember.
- Retain the inner articulation
using the bar
8.0906 J
and insert the outer pivot 2 in its
housing.
-
Then
insert the inner pivot
3
in the correct
direction of fitment.
- Fit the new "Nylstop" nuts without tightening
them.
- Place a jock under the rear port of the arm.
- Coot the upper rubber spring c1,1p with pure
Teepol
to facilitate its positioning.
- If
this component needs
replacing
check
for
condition of interchangeability indicated in pa-
ge 1103 class 9.
- Place the spring in between its upper and lower
mountings.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

504 saloon 1970504 coupe 1970504 convertible 1970

Table of Contents