PEUGEOT 504 Series 1970 Workshop Manual page 222

0
w
\.:J
:J
w
a.
DRIVE SHAFT
REFITTING
· The ports should be throughly clean and free
from any defect.
- Hold hub/ knuckle l in a vice.
- Smear the drive shaft splines, wheel side,
with Molykote 321.
· Engage the drive shaft into the hub.
- Fit washer
2.
- Hand tighten a
new
hub nut 3.
- Ensure perfect condition of lateral seal ring
4
on the differential housing.
- Smear the gap between the seal lips with
tallow or grease.
·Grease the drive shaft splines.
- Engage hub/knuckle/ drive shaft assembly in
its housing on suspension arm.
- Carefully introduce the drive-shaft splined end
into the differential housing.
- Using new Blocfor washers secure the knuckle
to the suspension arm.
- T ighten the Allen screws to
29 ft.lbs
(4 m.kg).
504 Workshop Monuol. Ref. 1212 E